During use:
1. When packing, if you have many heavy items or only heavy items, distribute them evenly. After putting it on, fasten and tighten the chest strap so thatthe backpackdoesn’t pull back, and while moving, hold onto theshoulder strapsandbackpackadjustment straps.
2.When passing through unprotected areas, loosen the backpack’sshoulder straps,open the waist belt and chest strap so that in case of danger, you can quickly separate yourself from the pack to ensure a lighter escape.
3.Do not throw or dropthe backpack, especially atightly packedBackpack, once the backpack is fully packed, the tension on the seams is already quite tight. If you roughly remove it at this point,backpack, or if it accidentally falls, it can easily cause the seams to break orbucklesto be damaged. Avoid placing hard metal items directly against thebackpackfabric: hard items such as utensils or cookware sets, if pressed against thebackpackfabric, can easilybackpackrub against hard surfaces like rocky walls or railings, and even slight friction can damage thebackpackThe fabric is worn through.
4.Be careful during the moving process.BucklesStrapsAccessories: When getting on the vehiclethere may be some pulling on the backpack, sothe backpackshould be checked to ensure the waist buckle is fastened when boarding. Somebackpackshave softer waist buckles that can be fastened in reversearound the lower part of the backpack. Somethe lower part, somebackpackshave waist belts supported by hard plastic panels, which cannot be fastened in reverse as they may easily crack. It’s best to use abackpack coverto cover thebackpackto prevent thestrapsfrom tangling with otherbackpacksand causing damage to thebackpackduring the pulling process.
1. It is recommended to use a dry, soft brush to remove dust from the exterior of thebackpackbefore washing with water. Wiping directly with a damp cloth may instead transfer stains onto the fabric surface.If there is grease, it’s best to use a neutral detergent. If unsure about the solution’s properties, you can substitute with bath gel or shampoo (these are generally neutral to slightly acidic).
2. After rinsing thoroughly, let it air dry in a shaded place. Do not expose it to direct sunlight, as UV rays can cause the fibers to harden and become brittle. After activities like stream trekking or long trips, soak the backpack for about 30 minutes or rinse it with plenty ofRinse with clean waterto prevent organic matter, small organisms, or decaying leaves in the stream water from getting trapped in the backpack's carrying system, which could cause mold or bacterial growth.
3. When the backpack is not completely dry,it is the best time to apply a professional water repellent spray. Apply some specialized outdoor waterproofing agents at this time. Once dried,the backpack’swater repellency will be as good as new.
2. Regularly check key support points such as the waist belt,shoulder straps,and the stability of the carrying system. Prevent padding from deteriorating or hardening unnoticed. Replace zippers when needed—don’t wait until items start falling out of thebackpackbefore fixing them.
3. Make sure thebackpackis completely dry and empty thebackpack,leaving nothing inside thebackpack.This prevents loss of items and avoidsstorage-relateddeformation caused by stacking items inside thebackpack.Finally, tighten thestrapsand buckles,then store it in a storage box to keep it dry. You can also spray some professional anti-bacterial and anti-mold sprays to prevent mold due to long-term storage.
Now that you know these backpack care tips, go give your beloved pack a good clean and maintenance~！