Tube-shaped Twist
Craft: Deep-fried by blanching
Ingredients: 2500g refined flour, 25g alum, 50–75g refined salt, appropriate amount of food-grade alkali, 5000g vegetable oil (about 1000g used).
Features: Shaped like a long tube, crispy and fragrant with a burnt aroma, offering a unique flavor.
Method:
1. Place alum, refined salt, and food-grade alkali in a basin, mix with about 1750g warm water, dissolve, then mix in the flour to form a flaky dough. Knead with water into a soft dough block, and let rest for about 20 minutes.
2. After the dough has rested, knead it well, divide into 300 small pieces (each about 15g), dip in oil and roll into olive shapes. Arrange them in a basin (oil the basin, and brush a layer of oil between each layer of dough pieces), then let rest for another 20 minutes. Roll each piece into a 40cm-long thin strip, then align and join the two ends to make two strips. Place them side by side on the work surface, bring the two ends together, and neatly coil them around an oiled cylinder (a specially made wooden stick, about 30cm long and 3cm in diameter). Lower into a pot of oil heated to 70–80% hot, remove the cylinder while frying, and use four long chopsticks (two in each hand) to keep turning the twists so they continuously roll in one direction in the oil. Stretch the twists (to about 33cm) and straighten them. When the twists puff up and bubble-like blisters appear inside the strands, and the color turns persimmon yellow, they are done.
Key Points:
1. The dough must be kneaded evenly and rested until fully smooth;
2. Keep the twists rolling continuously during frying, and do not over-fry.
This article is published by HowToTrip. Sharing and reposting are welcome — please credit the source.
Article URL: https://www.howtotrip.net/techan19744