Home › Local Specialties › White Scatter

White Scatter

Published: 2026-11-16 👁 100 views
Last updated 2026-11-16 — White Scatter, also known as rice crisp, is shaped like a round disc, white with a slight yellow tint, sweet, fragrant, and crispy—lightly pressed, it breaks into several pieces. Locals in Yulin commonly call it “White Scatter,” which reflects its clean, loose texture.

White Scatter

  White Scatter

  White Scatter, also known as rice crisp, is shaped like a round disc, white with a slight yellow tint, sweet, fragrant, and crispy—lightly pressed, it breaks into several pieces. Locals in Yulin commonly call it “White Scatter,” which reflects its clean, loose texture.

  The making of White Scatter follows a complete set of procedures:

  1. Ingredient selection. The glutinous rice used must be pure, large-grained, sticky, and white. After sieving out broken grains, it is soaked in a container overnight, then drained and dried.

  2. Steaming. The glutinous rice is placed in a steamer and steamed over high heat. The degree of cooking must be well controlled—overcooked rice becomes hard and compact, making it difficult to aerate, release from molds during shaping, or become fluffy when fried; it will also turn out hard and not crispy when eaten. Undercooked rice lacks stickiness, making it prone to falling apart during shaping and not puffing fully when fried.

  3. Molding. Wooden molds engraved with auspicious characters such as 吉 (good fortune), 福 (blessing), 喜 (joy), and 寿 (longevity)—available in large, medium, and small sizes—are used. The molding process must be done while the glutinous rice is still hot; quickly fill the mold, spread it evenly, slightly press it down, and then strike it onto a bamboo tray. If the rice is not hot enough, it lacks stickiness and won’t hold its shape.

  4. Sun-drying the molded pieces. Once cooled, the molded pieces are transferred to a bamboo sieve to dry in the sun. They should be turned frequently, sunned on both sides, until they are completely dry.

  5. Coating with sugar syrup. The dry molded pieces are immersed in pre-boiled sugar syrup (either white or brown sugar), then taken out once evenly coated—this is called “dragging through sugar syrup.” The concentration of the syrup must be well controlled: too thin and it won’t be sweet, too thick and the pieces won’t puff properly when fried. Typically, a ratio of three parts sugar to one part water is ideal. The coated pieces are then sun-dried and stored in a sealed container until ready to be fried.

  6. Frying. Tea oil is best; peanut oil is second best. Before frying, the molded pieces are sun-dried (or baked) again to remove excess moisture. Once the oil is boiling in the pan, place the pieces in one by one, with the smooth side facing down, and keep them moving continuously with long chopsticks to ensure they spin in the same direction. When the pieces float to the surface, flip them over with the chopsticks, press them down, and fry for another minute or two before removing them. Place them on a plate to drain excess oil, let them cool, and then seal them for storage.

Share

This article is published by HowToTrip. Sharing and reposting are welcome — please credit the source.
Article URL: https://www.howtotrip.net/techan29102

↑
0